Print

2024-07-01 20:25| 来源: 网络整理| 查看: 265

Key point 1: Make sure the ear fitting supporters are tucked under the ear groove in each ear.

If the ear fitting supporters are not placed correctly in the ear grooves, the LinkBuds can easily fall out.

3-1

3-2 3-1 (Incorrect): The ear fitting supporter is out of the ear groove, and the LinkBuds unit is falling out of the ear 3-2 (Correct): The ear fitting supporter is properly inserted in the ear groove, and the LinkBuds unit is fitted well

Follow these steps to insert the ear fitting supporters:

Tuck the ear fitting supporter into the ear groove of each ear and align the supporter with each ear groove (A).

The arch of the ear fitting supporters should be aligned vertically so that the driver units cover the lower part of the concha (near the opening of the ear).

Anatomy of the ear indicating the line of the ear groove (A)

The correct size ear fitting supporter tucked under the ear groove without it being bent

Check that the LinkBuds don't fall out of your ears. Key point 2: Check the fittings again to make sure that the sizes are correct for each ear.

Be careful to not force the ear fitting supporter as it may rotate the LinkBuds and cause the ear fitting supporter to pop out from under the ear groove.

3-3

3-4 3-3 (Incorrect): The ear fitting supporter is out of the ear 3-4 (Correct): The ear fitting supporter is securely in the ear

If the ear fitting supporter is too small, the supporter may fit loosely and fall out. If this happens, replace it with a larger size and check the fit again.

3-5

3-6 3-5 (Incorrect): The size is too small for the ear 3-6 (Correct): The size is correct for the ear Key point 3: Check the position of the driver units, housing units, and ear fitting supports to make sure they are properly positioned.

The driver units (B), housing units (C), and the ear fitting supporters (D) must be properly positioned while the LinkBuds are worn. For each ear, make sure the driver unit (B) covers the lower portion of the concha near the opening of the ear (G), the housing (C) is in between the opening of the ear and the ear groove (F), and the ear fitting supporter (D) is tucked under the ear groove (E):

B: The driver unit has the hole in the center and is the part that covers the ear hole (concha) C: The housing unit is the round piece which includes the touch sensor D: The ear fitting supporter tucks under the ear groove to hold it in place Anatomy of the ear showing the concha (G), line to fit the ear (F), and the ear groove (E)

Anatomy of the ear showing the concha (G), line to fit the ear (F), and the ear groove (E)

LinkBuds unit inserted in the ear with the ear fitting supporter fitted correctly

E: Ear groove F: Line to fit the ear G: Opening of the ear (Concha) Insert the driver (B) into the lower part of the opening of the ear (G). Align the housing (C) inside the ear groove line (F). Push the ear fitting supporter (D) under the ear groove (E).

【本文地址】

Print

Print

今日新闻

推荐新闻