求助：造成华为交换机的接口input方向CRC错误包的可能原因是什么？ |
您所在的位置：网站首页 › 华为交换机清除crc错误包命令 › 求助：造成华为交换机的接口input方向CRC错误包的可能原因是什么？ |
|
求助：造成华为交换机的接口input方向CRC错误包的可能原因是什么？
原创
hellab 2012-11-16 13:21:38 ©著作权 文章标签 接口 华为交换机 文章分类 网络安全 ©著作权归作者所有：来自51CTO博客作者hellab的原创作品，请联系作者获取转载授权，否则将追究法律责任dis interface XGigabitEthernet 4/0/11 | in CRC CRC: 1750973252, Giants: 0 CRC: 1751004173, Giants: 0 CRC: 1752098903, Giants: 0 CRC: 1754201207, Giants: 0 CRC: 1760134351, Giants: 0 CRC: 1760209544, Giants: 0 CRC: 1760507681, Giants: 0 dis int xg4/0/11 XGigabitEthernet4/0/11 current state : UP Line protocol current state : UP Switch Port, PVID : 80, TPID : 8100(Hex), The Maximum Frame Length is 9216 IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 4c1f-cc17-bc5e Last physical up time : Last physical down time : Port Mode: COMMON FIBER Speed : 10000, Loopback: NONE Duplex: FULL, Negotiation: DISABLE Mdi : NORMAL Last 300 seconds input rate 764993312 bits/sec, 692403 packets/sec Last 300 seconds output rate 4779330144 bits/sec, 488706 packets/sec Input peak rate 42180679464 bits/sec, Record time: Output peak rate 166402976000 bits/sec, Record time: Input: 1639371345048 packets, 265523246962955 bytes Unicast: 1637590381474, Multicast: 1764813 Broadcast: 5, Jumbo: 0 Discard: 0, Total Error: 2105528902 CRC: 1773580351, Giants: 0 Jabbers: 5618410, Fragments: 0 Runts: 0, DropEvents: 0 Alignments: 0, Symbols: 326330141 Ignoreds: 0, Frames: 0 Output: 1164874575397 packets, 1368632692411740 bytes Unicast: 1164872919414, Multicast: 1653243 Broadcast: 2739, Jumbo: 0 Discard: 0, Total Error: 0 Collisions: 0, ExcessiveCollisions: 0 Late Collisions: 0, Deferreds: 0 Buffers Purged: 0 Input bandwidth utilization threshold : 100.00% Output bandwidth utilization threshold: 100.00% Input bandwidth utilization : 7.65% Output bandwidth utilization : 47.79% 其直连的设备为cisco的7609，详细接口信息： sh int t8/1 TenGigabitEthernet8/1 is up, line protocol is up (connected) Hardware is C6k 10000Mb 802.3, address is 0016.c758.6c40 (bia 0016.c758.6c40) Internet address is 117.79.135.102/30 MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec, reliability 255/255, txload 19/255, rxload 119/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full-duplex, 10Gb/s, media type is 10Gbase-LR input flow-control is on, output flow-control is off ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:01, output never, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 4669998000 bits/sec, 487738 packets/sec 5 minute output rate 784167000 bits/sec, 685865 packets/sec L2 Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes L3 in Switched: ucast: 1163970975401 pkt, 1367570026262400 bytes - mcast: 0 pkt, 0 bytes L3 out Switched: ucast: 1639408809117 pkt, 265661180788828 bytes - mcast: 0 pkt, 0 bytes 1163989849194 packets input, 1367576748045297 bytes, 0 no buffer Received 1671094 broadcasts (0 IP multicasts) 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0 multicast, 0 pause input 0 input packets with dribble condition detected 1639420120437 packets output, 265662497679794 bytes, 0 underruns 0 output errors, 0 collisions, 3 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 PAUSE output 0 output buffer failures, 0 output buffers swapped out 谁能帮忙看下具体原因在哪？赞 收藏 评论 分享 举报 上一篇：ospf中的使用gre时的地址翻滚问题 下一篇：前缀列表(prefix-list)讲解 |
今日新闻 |
推荐新闻 |
| CopyRight 2018-2019 办公设备维修网 版权所有 豫ICP备15022753号-3 |