H3C交换机如何看端口的传输速率等信息

您所在的位置：网站首页 › 交换机清除 › H3C交换机如何看端口的传输速率等信息

H3C交换机如何看端口的传输速率等信息

#H3C交换机如何看端口的传输速率等信息| 来源: 网络整理| 查看: 265

环境：

H3C S6520交换机

问题描述：

H3C交换机如何看端口的传输速率

解决方案：

1.显示端口

display interface Ten-GigabitEthernet 1/0/6

Ten-GigabitEthernet1/0/6 Current state: DOWN Line protocol state: DOWN(LAGG) IP packet frame type: Ethernet II, hardware address: 1484-77e2-f757 Description: Ten-GigabitEthernet1/0/6 Interface Bandwidth: 10000000 kbps（传输速率） Loopback is not set Media type is not sure, Port hardware type is no connector Unknown-speed mode, unknown-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 1(default vlan), 100 VLAN permitted: 1(default vlan), 100 Trunk port encapsulation: IEEE 802.1q Port priority: 0 Last link flapping: Never Last clearing of counters: Never Current system time:2021-01-01 15:26:28 Last time when physical state changed to up:- Last time when physical state changed to down:2021-01-01 00:00:52 Peak input rate: 0 bytes/sec, at 2021-01-01 00:01:22 Peak output rate: 0 bytes/sec, at 2021-01-01 00:01:22 Last 300 seconds input: 0 packets/sec 0 bytes/sec -% Last 300 seconds output: 0 packets/sec 0 bytes/sec -% Input (total): 0 packets, 0 bytes 0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses Input (normal): 0 packets, - bytes 0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses Input: 0 input errors, 0 runts, 0 giants, 0 throttles 0 CRC, 0 frame, - overruns, 0 aborts - ignored, - parity errors Output (total): 0 packets, 0 bytes 0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses Output (normal): 0 packets, - bytes 0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses Output: 0 output errors, - underruns, - buffer failures 0 aborts, 0 deferred, 0 collisions, 0 late collisions 0 lost carrier, - no carrier IPv4 traffic statistics: Last 300 seconds input rate: 0 packets/sec, 0 bytes/sec Last 300 seconds output rate: 0 packets/sec, 0 bytes/sec Input: 0 packets, 0 bytes Output: 0 packets, 0 bytes IPv6 traffic statistics: Last 300 seconds input rate: 0 packets/sec, 0 bytes/sec Last 300 seconds output rate: 0 packets/sec, 0 bytes/sec Input: 0 packets, 0 bytes Output: 0 packets, 0 bytes

2.显示端口摘要

dis interface brief

Speed一列代表协商速率 Duplex一列代表双工模式（A为自动协商、F为全双工、H为半双工）

Brief information on interfaces in route mode: Link: ADM - administratively down; Stby - standby Protocol: (s) - spoofing Interface Link Protocol Primary IP Description InLoop0 UP UP(s) -- MGE0/0/0 DOWN DOWN -- NULL0 UP UP(s) -- REG0 UP -- -- Vlan1 UP UP -- Vlan100 UP UP Brief information on interfaces in bridge mode: Link: ADM - administratively down; Stby - standby Speed: (a) - auto Duplex: (a)/A - auto; H - half; F - full Type: A - access; T - trunk; H - hybrid Interface Link Speed Duplex Type PVID Description BAGG1 DOWN auto A T 1 BAGG2 DOWN auto A T 1 BAGG3 DOWN auto A T 1 XGE1/0/1 DOWN auto A T 1 XGE1/0/2 DOWN auto A T 1 XGE1/0/3 DOWN auto A T 1 XGE1/0/4 DOWN auto A T 1 XGE1/0/5 DOWN auto A T 1 XGE1/0/6 DOWN auto A T 1 XGE1/0/7 DOWN auto A A 100 XGE1/0/8 UP 10G(a) F(a) A 100 XGE1/0/9 UP 10G(a) F(a) A 100 XGE1/0/10 DOWN auto A A 1 XGE1/0/11 DOWN auto A A 1 XGE1/0/12 DOWN auto A A 1 XGE1/0/13 DOWN auto A A 1 XGE1/0/14 DOWN auto A A 1 XGE1/0/15 DOWN auto A A 1 XGE1/0/16 DOWN auto A A 1 XGE1/0/17 DOWN auto A A 1 XGE1/0/18 DOWN auto A A 1

3.视图模式下查看全部端口实时流量：

display counters rate inbound interface（入方向） display counters rate outbound interface （出方向）

【本文地址】

H3C交换机如何看端口的传输速率等信息

H3C交换机如何看端口的传输速率等信息

今日新闻

推荐新闻