|
Advertisement
Quick Links
x
Download this manual
7
Layout
8
Processor Support
8
Memory Support
8
Specifications
12
Atx 24-Pin Power Connector: Atx1
See also:
User Manual
Table of Contents
Copyright NoticeRevision HistorySafety InstructionsWEEE StatementTable of ContentLayoutIntroductionSpecificationsProcessor SupportMemory SupportSupported FSBChipsetConnectorsBack PanelOn-Board Pinheaders / ConnectorsSlotsForm FactorRear PanelHardware SetupCPU & Cooler Installation Procedures for LGA775Introduction to LGA 775 CPUInstalling Memory ModulesATX 24-Pin Power Connector: ATX1ATX 12V Power Connector: PWRCONN1Floppy Disk Drive Connector: FDD1IDE Connector: IDE1Fan Power ConnectorsFront USB ConnectorS/PDIF-Out Connector: JSPD1CD-In Connector: CD_IN1PCI (Peripheral Component Interconnect) Express SlotPCI (Peripheral Component Interconnect) SlotPCI Interrupt Request RoutingBIOS SetupMain PageStandard CMOS FeaturesAdvanced BIOS FeaturesFrequency/Voltage ControlLoad Fail-Safe DefaultsLoad Optimized DefaultsBIOS Setting PasswordAdvance DRAM Configuration > DRAM CAS# LatencyFsb/Memory RatioAdjusted DDR Memory FrequencyAdjust PCI FrequencyMontagePanneau Arri猫reInstallation Mat茅riellePage PrincipaleSpezifikationenHinteres AnschlusspanelBIOS SetupFrequency/Voltage Control袟邪写薪褟褟 袩邪薪械谢褜校褋褌邪薪芯胁泻邪 袨斜芯褉褍写芯胁邪薪懈褟袪邪蟹褗械屑褘袨褋薪芯胁薪芯械 袦械薪褞Pci Express
FCC-B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the measures listed below.
n
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and receiver.
n
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
n
Consult the dealer or an experienced radio/ television technician for help.
Notice 1
The changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Notice 2
Shielded interface cables and A.C. power cord, if any, must be used in order to comply with
the emission limits.
VOIR LA NOTICE D'NSTALLATION AVANT DE RACCORDER AU RESEAU.
Micro-Star International
MS-7267
G52-72671XH
Previous Page
Next Page
1
2
3
4
5
Advertisement
|