Ipv6 configuration (passthrough or 6RD tunnel ?)

您所在的位置：网站首页 › anythingwilldo翻译 › Ipv6 configuration (passthrough or 6RD tunnel ?)

Ipv6 configuration (passthrough or 6RD tunnel ?)

#Ipv6 configuration (passthrough or 6RD tunnel ?)| 来源: 网络整理| 查看: 265

Hi to everybody,

I live in Italy and I have Fastweb as ISP. My current network configuration is:

Internet Fastweb Router OpenWrt Router 21.02.3 (MqMaker Witi 512)

As far as I understood to provide IPV6 connectivity Fastweb uses a 6RD tunnel with an IPV6 prefix 2001:b07:xxxx:yyyy::/64 which should allow transparent connectivity to its LAN devices.

I did a fresh install of Openwrt 21.02.3 today (so I left ipv6 settings as default)...If I connect to Fastweb router's wifi I can navigate accurately to https://ipv6.google.com; if instead I connect to OpenWrt router's wifi I can't.

I am not too much on IPV6, I believed the router would also perform NAT on IPV6 getting a WAN IPV6 address from Fastweb router, assigning internal IPV6 to Openwrt router's LAN devices and NATting the connection between the two routers, but this does not seem to be the case.

Here it follows my /etc/config/network

config interface 'loopback' option device 'lo' option proto 'static' option ipaddr '127.0.0.1' option netmask '255.0.0.0' config globals 'globals' option packet_steering '1' option ula_prefix 'fd0f:6d9b:435a::/48' config device option name 'br-lan' option type 'bridge' list ports 'lan1' list ports 'lan2' list ports 'lan3' list ports 'lan4' config interface 'lan' option device 'br-lan' option proto 'static' option ipaddr '172.17.1.1' option netmask '255.255.255.0' option ip6assign '60' config interface 'wan' option device 'wan' option proto 'dhcp' config interface 'wan6' option device 'wan' option proto 'dhcpv6'

Can someone help me with the configuration ? Thank to anyone who can help me.

Federico

【本文地址】

Ipv6 configuration (passthrough or 6RD tunnel ?)

Ipv6 configuration (passthrough or 6RD tunnel ?)

今日新闻

推荐新闻