50W功放电路 (50Watt Amplifier)

This is a handy, easy to build general purpose 50 watt amp. The amp has an input for a radio, TV, stereo or other line level device. It also has a phono input for a record player, guitar, microphone or other un-amplified source. With the addition of a low pass filter at the input, it makes a great amp for a small subwoofer.

PartsPart Total Qty. Description R1 1 200 Ohm 1/4 W Resistor R2 1 200K 1/4 W Resistor R3 1 30K 1/4 W Resistor R5 1 1K 1/4 W Resistor R6 1 5K 1/4 W Resistor R7,R10 2 1 Meg (5%) 1/2 W Resistor R8,R9 2 0.4 Ohm 5 W Resistor R11 1 10K Pot R12,R13 2 51K 1/4 W Resistor R14 1 47K 1/4 W Resistor C1 1 100uF 35V Electrolytic Capacitor C2 1 0.011uF Capacitor C3 1 3750pF Capacitor C4,C6 2 1000pF Capacitor C5,C7,C8 3 0.001uF Capacitor C9 1 50pF Capacitor C10 1 0.3uF Capacitor C11,C12 2 10,000uF 50V Electrolytic Capacitor U1,U2 2 741 Op Amp U3 1 ICL8063 Audio Amp Transister Driver thingy Q1 1 2N3055 NPN Power Transistor Q2 1 2N3791 PNP Power Transistor

Notes1. I know I skipped R4. That is not a problem :-)

2. Distortion is less than 0.1% up to 100HZ and increases to about 1% at 20kHz.

3. I haven't been able to find anyone who sells a suitable T1. You can always use two 24V 5A units in series. If you are building two amps (for stereo), then I would suggest using an old microwave transformer and rewinding it.

4. Q1 and Q2 will require heatsinks.

5. You may have trouble finding U3 because it is discontinued. Please don't email me about sources...I can't find it either. A possible source was sent in by JBWilliams: